Autotuner has added OBD virtual read support for the Campi LIE2010 ECU, the engine controller used on Lamborghini V12 flagship models produced from 2011 to 2022. It is supported on the AutoTuner Tool and AutoTuner One, and the source does not describe the protocol as BETA.
Which ECUs
The release covers one controller: the Campi LIE2010, built around an MPC5567 processor. The mode is OBD virtual read. Autotuner says it reads the ASW and calibration, and adds specific datalogs and checksum correction. The listed write time is 6 minutes 45 seconds. As this is a virtual read release, we are describing the read side only, and a full write procedure is not something the source sets out.
Cars this opens up
The source names these Lamborghini models:
- Aventador
- Veneno
- Centenario
- Sian FKP 37
- Countach
Engine references in the article are the 6.5i V12 and the Lamborghini L539 V12, with production listed as 2011 to 2022. Anything outside that list should be checked with us before you plan a job.
Because the release is OBD based, the car stays whole while the data is read, which is a real advantage when the vehicle is a Countach or a Centenario and nobody wants panels off or the ECU on a bench.
What it means
These are low-volume, high-value cars, and until now getting at the ECU data has usually meant a more invasive route. Reading the ASW and calibration in the car over the OBD port keeps the car intact and cuts down the time it spends on a ramp. For owners, that means a quicker and tidier route to a bespoke file. For dealers, it means a faster turnaround on a type of job that does not come through often, and where care matters more than speed.
Datalogs and checksum correction matter on cars like these. Being able to log real engine behaviour before and after changes is how a V12 of this value should be developed, rather than relying on a headline gain. Power figures vary with the car, fuel and condition, so we only talk about typical gains once we have seen the car.
If you own one of these cars, our tuning builder is the place to start. Garages can look at our file service and the Autotuner tool page for how the tool fits into a workshop.
Pay with Klarna

















